Pole Barn Concrete in Lafayette, IN

Floors for pole barns, post-frame buildings and shops, planned around county permits and post-hole rules. Contact us for a free, no-pressure estimate.

Get Your Free Pole Barn Slab Estimate
*Indicates Required Field

New concrete driveway leading to a two-car garage
Why Choose Us

Pole Barn Concrete Contractor in Lafayette, IN

In unincorporated Tippecanoe County, pole barn post holes go 48 inches deep and get inspected before the poles are set. The floor has to work with that post layout and with whatever the barn will hold. We plan the permit, the posts and the slab together.

concrete contractors Lafayette IN
Our Pole Barn Work

Slabs for Barns, Shops and Post-Frame Buildings

Large concrete slab being finished next to a metal building
Pole Barn Floors

Concrete floors poured inside post-frame buildings, with an isolation joint around each post.

Crew placing concrete over rebar for a slab
Shop Slabs

Slabs for workshops and storage buildings, sized and reinforced for what you'll park or run on them.

Freshly poured concrete driveway with the forms still in place
Aprons & Approaches

A concrete apron at the overhead door, tied in to your drive and mixed for freeze-thaw.

How It Works

Three Simple Steps

Here is what to expect when you reach out about your pole barn slab.

pouring a concrete slab lafayette in

Pole barn permits around Lafayette

Unincorporated Tippecanoe County

Outside Lafayette and West Lafayette city limits, the Tippecanoe County Building Commission (20 North Third Street, Lafayette; 765-423-9225) issues building permits. The county rules that matter for a pole barn:

  • Permit first. County code § 151.07(A) says “A permit shall be obtained before beginning construction, demolition or alteration of any building or structure,” and the project is checked against the Unified Zoning Ordinance before a permit is issued.
  • Fee. The county figures the fee for pole barns, agricultural buildings and detached garages by the square foot. Call the Building Commission at 765-423-9225 for the current amount before you budget.
  • Post holes. The county FAQ says pole barn post holes are 48 inches deep (deck post holes are 30 inches), and post holes “must be inspected before poles can be set.”
  • Setbacks. Zoning questions, including how close the barn can sit to your property lines, go to the Area Plan Commission at 765-423-9242.
  • Small sheds. The county says no permit is needed for a shed “as long as it is less than 120 square feet and portable.”

Farm-only buildings

Indiana law (IC 22-12-1-4) leaves out of the Class 1 structure definition a building used only for an agricultural purpose on the land where it sits and not used for retail trade. The state Department of Homeland Security defines agricultural purpose as “cultivation of soil, the production of crops, or the raising of livestock,” and says such a building doesn’t need a design release and isn’t required to follow the building code. That guidance doesn’t say whether a county can still require a permit, and Tippecanoe County’s fee schedule lists agricultural buildings. Ask the Building Commission before assuming a farm barn needs no permit.

Inside Lafayette or West Lafayette

Lafayette’s permit FAQ says any shed over 120 square feet, or any shed on a permanent foundation, needs a building permit and has to meet accessory-structure zoning setbacks; ask Engineering at 765-807-1050 about a larger building. In West Lafayette, the accessory building permit is $250 (plan review, three inspections and the certificate of occupancy) plus $2 per $1,000 of estimated cost, with a plot plan drawn to scale showing setbacks. The Building Department is at (765) 775-5130.

Posts, frost depth and the floor

Indiana’s frost-protection rule (R403.1.4.1 in the 2020 Indiana Residential Code) requires foundation walls, piers and other permanent supports to extend below the depth listed in the state’s Table R301.2(1), or to be protected another approved way. For Tippecanoe County, that table lists 30 inches from finish grade to the bottom of the footing. The county’s 48-inch pole barn post holes go deeper than that, and the county inspects them before the poles go in. If your barn is across a county line, check that county’s figure: the same table lists White, Carroll and Benton counties at 36 inches.

Once the posts are set, the floor has to work around them. NRMCA calls for isolation joints between slabs and columns, so each post gets one and the slab isn’t locked to the frame.

Sizing the slab for what the barn holds

Indiana’s code sets a minimum of 3 1/2 inches for slab-on-ground floors, and HomeBlue’s Lafayette slab figures assume reinforced slabs 4 to 6 inches thick, noting that thicker commercial and foundation slabs cost more. What sets the number on your barn is the load:

  • Vehicles and equipment. ConcreteNetwork’s driveway guidance is 4 inches for passenger vehicles and SUVs, and 5 to 6 inches for heavier truck traffic or a large RV. A tractor, skid steer or loaded trailer is something to tell us about before we price the job.
  • Reinforcement. ConcreteNetwork’s guidance is wire mesh for 4- to 5-inch slabs and rebar at about 12-inch spacing for 5 inches and up. NRMCA says synthetic fibers help with early shrinkage cracks but don’t replace structural steel.
  • Joints. NRMCA puts maximum joint spacing at 24 to 36 times the slab thickness, capped at 15 feet. On a 6-inch floor the math gives 12 to 18 feet, so the 15-foot cap controls.
  • Strength and air. The 2018 IRC’s Table R402.2, the base of Indiana’s code, sets garage floor slabs at 3,500 psi with 5 to 7 percent air in Severe weathering areas like Tippecanoe County, and interior slabs on grade other than garage floors at 2,500 psi. If the barn will park vehicles, ask the building office which row it applies to your floor. Aprons outside the doors are exterior slabs, where NRMCA recommends about 6 percent air and 4,000 psi.
  • Vapor retarder. If part of the barn will be heated, NRMCA’s guidance is a vapor retarder at least 10 mils thick under interior floor slabs.

Big pours in cold weather

At the Purdue University Airport station, the median date of the first 28-degree night in fall is October 28 (NOAA 1991 to 2020 normals). ACI 306R-16 defines cold weather as air that has fallen to, or is expected to fall below, 40 degrees during the protection period. NRMCA’s cold-weather guide recommends placing concrete at 55 degrees or warmer for sections under 12 inches thick, protecting it from freezing until it reaches 500 psi, and, for concrete that will see freeze-thaw cycles, until it reaches 3,500 psi. Insulated blankets and tarps, or straw covered with plastic sheets, are the usual tools. And ConcreteNetwork’s rule holds for any floor: never place concrete on frozen ground, ice or snow.

For a sense of scale, a 30 x 40 floor poured 6 inches thick takes about 22 cubic yards of concrete. At HomeBlue’s Lafayette price for 4,000 psi ready-mix, that is roughly $3,100 to $3,200 in concrete alone, before delivery, base stone, steel, forming and labor.

Pole barn slab costs around Lafayette

These are published cost-guide figures, not our prices. Base work, thickness and access can move a barn slab’s price a lot, and the estimate is free.

ItemRangeSource
Reinforced slab, Lafayette area, per sq ft$7 to $11HomeBlue, Sept. 27, 2024
30 x 40 ft reinforced slab, Lafayette area$11,000 to $18,800HomeBlue, Sept. 27, 2024
40 x 60 ft reinforced slab, Lafayette area$21,900 to $37,600HomeBlue, Sept. 27, 2024
Ready-mix, 4,000 psi, Lafayette area, per cubic yard$138 to $145HomeBlue, Mar. 5, 2025
Pole barn slab floor, national, per sq ft$5 to $10HomeGuide, no date shown

Sources: HomeBlue, Lafayette, IN concrete slab cost (September 27, 2024; reinforced 4- to 6-inch slabs, staining and stamping not included, demolition extra at $1.20 to $1.90 per square foot), HomeBlue, Lafayette, IN concrete cost per yard (March 5, 2025; material only, with delivery listed at $120 to $260 per truckload and orders under 10 yards possibly costing more), and HomeGuide, pole barn prices (no date shown; checked November 3, 2026). HomeGuide’s own 40 x 60 pole barn cost page puts the slab at $6 to $12 per square foot, so its national figures don’t agree with each other.

What moves the price: grading (HomeGuide’s national figure is $0.40 to $2.00 per square foot), thickness and steel, base stone, truck access across the yard, cold-weather protection, and the permit. Call (765) 544-3470 or use the form to get a number for your barn.

Pole Barn Slab FAQs

How deep do pole barn post holes go in Tippecanoe County?

The county FAQ says 48 inches, and the holes must be inspected before the poles are set. The state table lists 30 inches for the county, but the county’s stated practice for pole barns is deeper.

What does a pole barn permit cost in the county?

The county charges by the square foot of building. Call the Building Commission at 765-423-9225 for the current fee.

Does a farm building need a permit?

Indiana exempts farm-only buildings from the building code and design release, but the state’s guidance doesn’t address county permits, and the county fee schedule lists agricultural buildings. Ask the Building Commission first.

How thick should a pole barn floor be?

It depends on what the barn holds. The code minimum for slab-on-ground floors is 3 1/2 inches; ConcreteNetwork’s driveway guidance is 4 inches for cars and 5 to 6 inches for heavier trucks or an RV.

How close to the property line can I build?

In unincorporated Tippecanoe County, setbacks come from the Area Plan Commission at 765-423-9242. In West Lafayette, the permit’s plot plan has to show them.

Where we work

We pour pole barn and shop floors around Lafayette and out into the countryside, including Battle Ground, Brookston, Monticello, Delphi and Attica. Visit our home page for slabs, driveways and the rest of what we pour.

Your Local Concrete Experts

Get A Free Estimate

Give us a call now or fill out the form above to get your 100% free, no-pressure estimate on your pole barn slab.

Call (765) 544-3470